Re: Iron Man Mark III Helmet 3d Print Files
As far as I'm aware, the files are scaled to roughly a Xxl sized head. That was in 3ds Mac though. But I'm pretty sure the Stl files are to the same scale though. I may have some problems with my sizing. I'll check on that this weekend and re upload if necessary. Worst case scenario I'd just scale up the Stl.
Thanks for checking it out!
Hmmm.
I loaded the repaired faceplate file into my printer, and it said it would take less than 2 min to print (my printer ain't that fast). So then I loaded it into STL viewer and the height of the faceplate is just over 9mm?
Am I doing something wrong here, or are the files off? If I get some time today, I'm going to load the STL into solid works and see what I see.
Thanks,
C
As far as I'm aware, the files are scaled to roughly a Xxl sized head. That was in 3ds Mac though. But I'm pretty sure the Stl files are to the same scale though. I may have some problems with my sizing. I'll check on that this weekend and re upload if necessary. Worst case scenario I'd just scale up the Stl.
Thanks for checking it out!