Felgacarb
Sr Member
So, I finally got my Diamond Select ST:III Phaser that I had pre-ordered, so, so long ago.
Overall, I rather like it. Here it is, next to my own 3D printed version:
It looks like the overall dimensions are more accurate than mine. They have an odd contour on the grip that I haven't been able to match in any screen caps- and they clearly left out the groove on the sides of the P1. And, of course, the colors could be slight better-
But that all makes this a great, not-so-expensive replica to modify!
My plan:
Take the dang thing apart. I'll probably have to drill out the screw covers...
Make a pop-out clip, so that I can wear it without a holster. (Heck, If I can make it work well, I may be able to offer that as a clip kit...)
Fill the seam lines and sand- and paint it up properly.
So, more to come...
Overall, I rather like it. Here it is, next to my own 3D printed version:
It looks like the overall dimensions are more accurate than mine. They have an odd contour on the grip that I haven't been able to match in any screen caps- and they clearly left out the groove on the sides of the P1. And, of course, the colors could be slight better-
But that all makes this a great, not-so-expensive replica to modify!
My plan:
Take the dang thing apart. I'll probably have to drill out the screw covers...
Make a pop-out clip, so that I can wear it without a holster. (Heck, If I can make it work well, I may be able to offer that as a clip kit...)
Fill the seam lines and sand- and paint it up properly.
So, more to come...
Last edited: