I was lucky enough to win one of the rare MACO scanners back in the good old IAW auctions.
I've been using a digital calipers and using exact mm measurements I made a 3D model which I had parts printed up for quite some time ago but it's taken a while to get back to this as I've been busy on a couple of commissions.
I've split some of the parts up from the model to make clean up a lot easier and to make this a good kit to put together.
Just a quick picture to whet your appetites!
I've had a couple of laser cut acrylic pieces done to allow me to back light the graphic and make this a hero prop, with battery access in the back the same as the original prop.
MACO Scanner by JamieThomas28, on Flickr
I've been using a digital calipers and using exact mm measurements I made a 3D model which I had parts printed up for quite some time ago but it's taken a while to get back to this as I've been busy on a couple of commissions.
I've split some of the parts up from the model to make clean up a lot easier and to make this a good kit to put together.
Just a quick picture to whet your appetites!
I've had a couple of laser cut acrylic pieces done to allow me to back light the graphic and make this a hero prop, with battery access in the back the same as the original prop.
MACO Scanner by JamieThomas28, on Flickr