-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Limited Run Leia and Chewie ANH brass handcuffs
- Thread starter eethan
- Start date
thank you, since I know you get a kick out of those, here is a pic of the Dunkeys for you because you've been nice :-D I gave them apples this morning so they were particularly interested :-D They are all doing good at this time by the way. Last month was absolutely crazy with the animals, aver 2000€ of vet bills, I was at the vet every two days, but I hope this is behind us now.
In other news, I have managed to find another detail to procrastinate on today, I saw on a previous photo I posted that the machining marks were annoyingly visible on the back end of the clasps and clashing in their orientation with the rest of the cuff, so I decided to sand those instead of doing the last step of assembly!
cheers!
The donkeys are back! And they know where to go for a snack! LOL I love it!
Sorry to hear about the vet bill, but thankfully they are ok. I wicked enjoy the donkey pictures!
Hey there,
Working on screws today! I sanded half of the remaining clasps too, but my fingers were too sore to finish all.
those brass screw must not have any QC, I have to go through all of them and see if they have flaws, like this:
a few didn't even have threading on them ahah
those that are good, I machine them clean and to the exact diameter I need to fit the holes perfectly like I explained in a previous test post. But I also have to file the back of the head a bit to remove the burrs that would prevent the head to sit correctly in its hole:
there we go, clean contour and no burrs:
this x100!
27 rejects out of 127 screws!! Luckily I'm not that bad with my machined parts!
then, I cut and threaded a small aluminium cylinder to attach the screws the other way around, and I now have to remove 2.4mm on each screw so they are the proper length!
small annoying things, but some good progress
cheers all!
Working on screws today! I sanded half of the remaining clasps too, but my fingers were too sore to finish all.
those brass screw must not have any QC, I have to go through all of them and see if they have flaws, like this:
a few didn't even have threading on them ahah
those that are good, I machine them clean and to the exact diameter I need to fit the holes perfectly like I explained in a previous test post. But I also have to file the back of the head a bit to remove the burrs that would prevent the head to sit correctly in its hole:
there we go, clean contour and no burrs:
this x100!
27 rejects out of 127 screws!! Luckily I'm not that bad with my machined parts!
then, I cut and threaded a small aluminium cylinder to attach the screws the other way around, and I now have to remove 2.4mm on each screw so they are the proper length!
small annoying things, but some good progress
cheers all!
Hi, I can add you to the backup list but the Chewie list is quite long. You'll have more luck with the Leia if you want.
Cheers
Similar threads
