erv
Well-Known Member
I'll to order to customers in a group email asap. Don't freak out if I don't answer to you individually for now, I'm keeping all PMs and emails, then I'll move from here somewhere next week as I'm still in the middle of a shipping madness for other boards.
Now that all parts have been figured out, as well as assembly for both my "mutated" proto and SD one, I can start sourcing locally the same parts as he uses so that the kits shipping from me are merely identical.
I'll provide :
- the sound board with preloaded and configured SD card
- the side led panels with leds mounted on them
- rear leds (triangle / square)
- Some super thin wire, 80 cm or 1m x 9 colors
- trigger and "DNA recognition" switches
- speaker
- mag sensor + magnet
- 9V coupler and main power supply switch (slider)
- a 9V battery if I can find a proper source, otherwise, just use your own duracell
I will *NOT* provide any wiring service, sorry :confused. I don't have the time for pre wiring 20+ kits plus unless you're working on a run like SDS (ie, you specify yourself where to place things with a 1mm accuracy) with templates, it's impossible to prepare a wire harness (well... rastnest) at the exact right length for everyone. Wiring is all yours, a clear and simple wiring PDF document will be provided.
You don't need to add any resistors, they will be on-board.
Later by email for detail on kit cost and shipping options/costs.
Now that all parts have been figured out, as well as assembly for both my "mutated" proto and SD one, I can start sourcing locally the same parts as he uses so that the kits shipping from me are merely identical.
I'll provide :
- the sound board with preloaded and configured SD card
- the side led panels with leds mounted on them
- rear leds (triangle / square)
- Some super thin wire, 80 cm or 1m x 9 colors
- trigger and "DNA recognition" switches
- speaker
- mag sensor + magnet
- 9V coupler and main power supply switch (slider)
- a 9V battery if I can find a proper source, otherwise, just use your own duracell
I will *NOT* provide any wiring service, sorry :confused. I don't have the time for pre wiring 20+ kits plus unless you're working on a run like SDS (ie, you specify yourself where to place things with a 1mm accuracy) with templates, it's impossible to prepare a wire harness (well... rastnest) at the exact right length for everyone. Wiring is all yours, a clear and simple wiring PDF document will be provided.
You don't need to add any resistors, they will be on-board.
Later by email for detail on kit cost and shipping options/costs.