I just received my tie and also the cnc produced name tag.
I measured the length of my own index finger, from knuckle to first joint, which was about 5 cm, and the height of the name tag was about 80% of that.
Based on that, I guesstimated it to be about 4 cm, but since this is a US made movie, 1,5"sounds like an option. (3,8 cm).
The length was judged after doing a 3d model and rotating to match, and about 7 cm seemed to work pretty good. Might be 3 inches or slightly under for you with imperial units.
The name tag shown below is 40 mm by 70 mm.
The font was chosen after putting a layer above a screen cap and finding the closest font. This is fairly close I think.
Any comments?
View attachment 1486566