Unlimited Run De Agostini Millennium Falcon 3D printed upgrades

[LrdSatyr8]

That front wall end does need to sit back behind the wall DeAgo gives us. Battery pack is in that area, hopefully there's room, looks like UK is getting that part this week.

Actually it does... the wall sits right in the middle of that area. The ribbed supports should go right against the wall itself. The large tube should be behind those supports which would put the tube BEHIND the wall itself. The problem of the battery pack however, that may or may not be much of a problem. If they intend to use the supplied battery pack, it should fit in nicely with alot of room to spare. If they plan to create a whole new battery compartment, then trimming might need to be done but it shouldn't be much of a problem.

 

[Tom1971]

His wall has the top beams going all the way back. That seems to help create the storage areas on top where the white trash bags are???? Yours stop before going across the back.

 

[LrdSatyr8]

His wall has the top beams going all the way back. That seems to help create the storage areas on top where the white trash bags are???? Yours stop before going across the back.



http://images4.sw-cdn.net/model/picture/625x465_3254056_9596586_1429747787.jpg
http://www.party-ideas-by-a-pro.com...-birthday-party-games-lightsaber-training.jpg

That's because with mine you have to cut a hole out in the back wall and fit it into it... like this:

Make more sense now?

His rack glues onto the wall itself... so there's no depth in it... like this:

 

[Tom1971]

Excellent. Now it makes sense.

Thank you sir.


Tom

- - - Updated - - -

Can you show a pic of the hole you had to make in the wall without the piece in place???

Tom

 

[LrdSatyr8]

The entire backside of the piece is one rectangular part... so you place is against the wall and trace the backside against it (make note of where the bottom struts sit on the floor) and then use that as the cutting guide.