BLTouch v31 and an ENDER3 (not ender3 pro)

Thread starter Crewman 6
Start date Oct 16, 2020

Crewman 6

New Member

Oct 16, 2020

Hello all. I have a PRUSA printer that was down for some time, they are not so easy to trouble shoot! So in the interm I got an Ender3 which turned out to be a good little printer! I wanted the auto bed leveling so I got a BLTouch and was it a PAIN to upgrade!! There are a lot of things they don't tell you. So, for those of you into 3D printing and are interested I documented my process step-by-step on the upgrade, note -I have 3 friends who have used my document with success-, and am uploading it for you to use. Have fun and good luck.

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.