gt350pony66
Master Member
Many thanks my brother!I don't comment a lot, but it has been fun watching this build come together.
Many thanks my brother!I don't comment a lot, but it has been fun watching this build come together.
Page one?Looking great! Back to page 1 with you.
The thread had fallen on to page 2 so I was bumping ya.Page one?
Oh, I see, well thanks brother lolThe thread had fallen on to page 2 so I was bumping ya.
Yeah, I could probably rip the bottom off and do it again but if the four one still works and that’ll do, it’s in the rear, the front should be ok as long as I’m more careful. These were an afterthought thoughSucks about the fibers. Superglue is like Kryptonite for them
All things considered though, it is a massive undertaking and you have made surprisingly quick progress
It doesn’t matter WE know why it’s there!I’m not certain this is going to throw sufficient light on the lettering but it is what it is
"These are the smallest light source we offer, much, much smaller than our 0402 SMDs and are like the head of a straight pen... they are that small! In fact, these are so small that the normal numeric numbering system really doesn't apply with these. That is why we call these units "SMALLEST SMD"
Well, I suppose I could get away with prying up some of the outer parts and hide the wiring with something like that. I’ll look into that, thanks Blake!Sucks about the fibers, but the font for the nameplate looks great
Maybe an alternative to the fibers could be something like these extremely tiny things which are probably as small as the fibers themselves
5 PACK SMALLEST SMD WHITE
hdamodelworx.com
Well, I suppose I could get away with prying up some of the outer parts and hide the wiring with something like that. I’ll look into that, thanks Blake!
Well the pod is all buttoned up now, I’d have to lift some plating and make a tiny tunnel for the wires which would be delicate surgery but not impossible. I just hate to finish it off and regret later not doing something. I ordered some Z size smd’s from Evan Design this morning so I’m gonna have at itWithout knowing much about what would be involved, or how much room there is, could you drill through to the interior roof and run the wires that way? They could be disguised as piping or roof details?
But then again, not sure how long the wires are or how much of a problem the resistors will cause