AT-ST by Bandai

OK,...did a wee bit of painting last night,....


I painted the cockpit interior,...even though it'll likely never be seen ::)


IMG_2106.jpg



IMG_2107.jpg



IMG_2108.jpg



IMG_2109.jpg



IMG_2110.jpg



Thats it,.....there was a piece that fell off on the outside of the head,...I had weathered it with oils & turps & although I had primed everything the wash must have ran down the back of the part & weakened it...


No biggie,...I just cemented it...BUT...theres something funny about the plastic on this kit definitely


J
 
So I cut mine off the sprue today. Wow, that one with the wookie on it is made with the worst plastic! Give me that hard fine molds plastic any day!

It's no surprise that people are having problems with it
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top