Ryusui
Well-Known Member
Hey all.
I have two MR Neuralyzers and one of which is not operating properly. The kill switch seems to be jammed too far into the shaft and will not cut the electronics when in the closed position. I tried calling MR to get a repair or replacement done, but it was way past warranty date, so I'm on my own.
Has anyone here taken one apart? How do I go about doing it? I assume the electronics are attached to the battery compartment and slide out with it...but I cannot seem to get it disengaged from the main tube. Other than that, I cannot find any other means of access to the innards.
Hopefully someone here can aid me with this small task. Thanks...
I have two MR Neuralyzers and one of which is not operating properly. The kill switch seems to be jammed too far into the shaft and will not cut the electronics when in the closed position. I tried calling MR to get a repair or replacement done, but it was way past warranty date, so I'm on my own.
Has anyone here taken one apart? How do I go about doing it? I assume the electronics are attached to the battery compartment and slide out with it...but I cannot seem to get it disengaged from the main tube. Other than that, I cannot find any other means of access to the innards.
Hopefully someone here can aid me with this small task. Thanks...