Assistance with MR Neuralyzer

Discussion in 'Replica Props' started by Ryusui, Feb 27, 2006.

  1. Ryusui

    Ryusui Well-Known Member

    Trophy Points:
    555
    Hey all.
    I have two MR Neuralyzers and one of which is not operating properly. The kill switch seems to be jammed too far into the shaft and will not cut the electronics when in the closed position. I tried calling MR to get a repair or replacement done, but it was way past warranty date, so I'm on my own.

    Has anyone here taken one apart? How do I go about doing it? I assume the electronics are attached to the battery compartment and slide out with it...but I cannot seem to get it disengaged from the main tube. Other than that, I cannot find any other means of access to the innards.

    Hopefully someone here can aid me with this small task. Thanks...
     
  2. Ryusui

    Ryusui Well-Known Member

    Trophy Points:
    555
    Bump for maximum assistance possibilities. :D
     
  3. Ryusui

    Ryusui Well-Known Member

    Trophy Points:
    555
    One last bump...
     
  4. temponaut

    temponaut Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,576
    Wow, no responses? Wish I could help you. I've got an MR Neuralyzer, but have never taken it apart. I guess after you experiment a little, you'll be the board's expert. :)

    Have you tried posting your inquiry over at ASAP? There's a dedicated Men in Black forum over there (actually, it's a combination Matrix/MiB forum). Maybe somebody over there will have an answer for you.

    ASAP: Matrix/MiB Forum

    Good luck.
     
  5. Ryusui

    Ryusui Well-Known Member

    Trophy Points:
    555
    Thanks for the reply.
    Hopefully someone can come forward with some info. :)
     

Share This Page