3D Printing- Doing My Research

yanchus

yanchus

New Member
Thinking about trying out some 3d Printing- probably on a P1 or P2 Bio.

Looking for those who have worked with 3d Printing of Bios. Any help, info, tips, files, etc you can share, would be very helpful.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top