1:3 Scale Judge dredd Figure WIP

Discussion in 'General Modeling' started by judgedredd, Feb 21, 2012.

  1. judgedredd

    judgedredd Sr Member

    Trophy Points:
    1,242
    My latest challenge is a 1:3 (24 inch) Judge Dredd Figure i have done 2 dredd figures in the past 1:3 and 1:5 just thought i would see if i could do a better job as they were pretty crap :)
    Still lots to do i just finished the main body which was made from sculpey and the helmet and face i am not very good at faces so if anyone who can actually sculpt fancies doing me a stallone nose and Jaw please let me know :)
    [​IMG]
    [​IMG]
     
  2. kelpy

    kelpy Member

    Trophy Points:
    182
    Lookin good.
     
  3. GrimmOmen

    GrimmOmen Member

    Trophy Points:
    191
    What materials are you using for your sculpt? It's looking terrific!


    -Grimm
    (Sent from my iPad using Tapatalk HD)
     
  4. Tobot

    Tobot Active Member

    Trophy Points:
    341
    Very nice, what era is the helmet? I stopped reading 2000ad around 2001
     
  5. judgedredd

    judgedredd Sr Member

    Trophy Points:
    1,242
    Hi i have had a professional sculpter do the face for me as it wasnt stallone enough.I am using sculpey for the main body and milliput for bits and bobs i need to get cracking on it again been busy with DIY but it stops me rushing it :)
    I am getting the lawgiver and some of the shoulder parts laser cut i need some 3d models of the badges making so i can get shapeways to rapid prototype them for me so if anyone can help with those that would be great?
    Cheers


     
  6. judgedredd

    judgedredd Sr Member

    Trophy Points:
    1,242
    The helmet is the Stallone movie version 1995 :)


     
  7. kelpy

    kelpy Member

    Trophy Points:
    182
    Why don,t you go for the new up coming Dredd film :thumbsup
     
  8. judgedredd

    judgedredd Sr Member

    Trophy Points:
    1,242
    I love the 95 Dredd props and costumes the new movie doesnt do it for me :)

     

Share This Page