3d printed alien larvae.

shokk

Active Member
Printed on cr10s, model available on thing verse.
Nice to make, I cut the model down the centre to avoid using supports.
3b143b89cc1fe8413c7ab722de504de1.jpg
7c564205906166c0f6ab57f00b0d8e73.jpg
2bf60c3376d564cb6dff79e5ebddc017.jpg


Sent from my LG-H815 using Tapatalk
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top