I've sent a new model off to Roy to do some more comparisons.
The changes I made were.
- I restored the length of the booster to where is was on my last run, since Scottjua has said that it matched the original quite closely, and since it looked a little short in the comparisons that Roy did.
- I enlarged the pommel cubes a bit, widening them out and playing with the geometry a bit to get them to match the FB photo.
-I made the emitter plate flat, and added the second set screw hole.
I played around with a bunch of different grip ridge patterns, but decided not to change the grips, since the comparison photos from Roy show that I have that section pretty much nailed down.
Let's see what Roy come's up with when he overlays my drawings on the available shots and we'll go from there.
The changes I made were.
- I restored the length of the booster to where is was on my last run, since Scottjua has said that it matched the original quite closely, and since it looked a little short in the comparisons that Roy did.
- I enlarged the pommel cubes a bit, widening them out and playing with the geometry a bit to get them to match the FB photo.
-I made the emitter plate flat, and added the second set screw hole.
I played around with a bunch of different grip ridge patterns, but decided not to change the grips, since the comparison photos from Roy show that I have that section pretty much nailed down.
Let's see what Roy come's up with when he overlays my drawings on the available shots and we'll go from there.