I've had a few people message me about how I drilled out my top resistor hole. I just wrote up a little tutorial for him. So I figured I should share it here
I don't know if you need to do this to rudy's latest run. But I know the 1st and 2nd run required it. So here it goes!
Step 1: strip the saber down so it looks like this
Step 2: use a sharpie and mark the first hole
Step 3: use a 1/16th Allen key wrench to remove the grub screw in the back of the chamber
Now the cage is separated from the chamber
Step 4: where the sharpie mark is, now drill that out with a 5/32nd drill bit
Step 5: blow the shavings off and attach the cage back to the chamber. Be sure to align the new hole you drilled with the threaded hole of the cage
Step 6: now take a small file, I grabbed this set cheap at Walmart. And slowly file this side of the clamp holes
That's it! Your done, assemble the clamp onto the cage and hold it in place by screwing the resistors in
Hope this helps!
Sent from my iPhone using Tapatalk
I don't know if you need to do this to rudy's latest run. But I know the 1st and 2nd run required it. So here it goes!
Step 1: strip the saber down so it looks like this
Step 2: use a sharpie and mark the first hole
Step 3: use a 1/16th Allen key wrench to remove the grub screw in the back of the chamber
Now the cage is separated from the chamber
Step 4: where the sharpie mark is, now drill that out with a 5/32nd drill bit
Step 5: blow the shavings off and attach the cage back to the chamber. Be sure to align the new hole you drilled with the threaded hole of the cage
Step 6: now take a small file, I grabbed this set cheap at Walmart. And slowly file this side of the clamp holes
That's it! Your done, assemble the clamp onto the cage and hold it in place by screwing the resistors in
Hope this helps!
Sent from my iPhone using Tapatalk