Started in on the LEDs . . .
After I got all the red ones soldered it ended up looking a bit like a spider's nest. lol
I didn't have a super tiny slider switch so I just used this push button switch I had on-hand.
I wired these up in parallel with a single resistor and because the red LEDs have a lower voltage than the green I wasn't able to keep them all in the same circuit.
I'll be creating a separate circuit with a separate switch and power source for the green LEDs.
Initial install:
On to the green LEDs:
New aluminum replacement greeble :cool
I'll be wiring these up tonight.
If anyone is interested in an upgrade kit of sorts for their PKD Water Gun Blade Runner Fullcock Takagi Type Blaster by ELFIN KNIGHTS. I've started an interest thread here:
https://www.therpf.com/showthread.php?t=281852
I was thinking of offering a kit that would include:
- Replacement allen bolts
- A few of the upgraded greebles
- LEDs
- Switches
- Batteries
- Instructions on how to install everything, etc.