@Kylo1 can you be a little more specific about which part is wobbling?[/QUOTE
The whole of the rest of the gun seems slightly loose from the grip. If I hold the handle grip tightly and gently shake from side to side, there is a little play with the rest of the gun as if the handle isn't tightly attached to rest of the gun. Not excessive play but definitely doesn't feel solid. Hard to put into words so hope this description helps.
These are the three(indicated by my thumb) that actually make contact with the revolver grip. Tighten them and you should be fine.@Kylo1 can you be a little more specific about which part is wobbling?[/QUOTE
The whole of the rest of the gun seems slightly loose from the grip. If I hold the handle grip tightly and gently shake from side to side, there is a little play with the rest of the gun as if the handle isn't tightly attached to rest of the gun. Not excessive play but definitely doesn't feel solid. Hard to put into words so hope this description helps.
These are the three(indicated by my thumb) that actually make contact with the revolver grip. Tighten them and you should be fine.
View attachment 796120View attachment 796121View attachment 796122
Thanks for that. I’ve taken the grips off and tightened those highlighted as much as I dare. It’s still not 100% solid but certainly better thank you. I’m planning on leaving this Tomen in an “as new” condition which is why I’m being so careful with it.
Thanks for that. I’ve taken the grips off and tightened those highlighted as much as I dare. It’s still not 100% solid but certainly better thank you. I’m planning on leaving this Tomen in an “as new” condition which is why I’m being so careful with it.
Just completed the re-finish of 2049 and came across the same problem, I tightened the two slot screws on either side of the main frame and seems to have done the trick, hope this helps.
Last I checked on HCG it said late Feb or 1st week of March.
I feel so dumb asking this question but I can't find it in the instructions or online. How do I open the barrel to install the bullets? :facepalm
hey, just push with your thumb on the cylinder release on top of the left side grip. then pull gently on the side cover. if it doesn't open, then it's jammed, it happens with the tomens sometimes.
I feel so dumb asking this question but I can't find it in the instructions or online. How do I open the barrel to install the bullets? :facepalm