Thanks guys for the kind words! Panaflex You know it brotha! Just a matter of time.
I did get a few questions on my PM from some of the members, about the assembly and how its being held together.
I'm using one of romans static rods and emitter cone. In my case the cone just required a little bit of sanding around the edge and it went in to my BP pretty good. its tight enough to hold it firmly in place, but I can pull it out with just a bit of force. On the other side ( inside the pommel wheel) I have a hex nut that I trimmed down to fit in the cavity. Also had to drill the square hole of the hand wheel to fit my Romans rod. As for the spacer, I just cut one out myself out of some stainless steel tubing I had left over.
I did get a few questions on my PM from some of the members, about the assembly and how its being held together.
I'm using one of romans static rods and emitter cone. In my case the cone just required a little bit of sanding around the edge and it went in to my BP pretty good. its tight enough to hold it firmly in place, but I can pull it out with just a bit of force. On the other side ( inside the pommel wheel) I have a hex nut that I trimmed down to fit in the cavity. Also had to drill the square hole of the hand wheel to fit my Romans rod. As for the spacer, I just cut one out myself out of some stainless steel tubing I had left over.
Last edited by a moderator: