yuumi2891103
Master Member
The busiest month has been over and I was back to build in a couple of days ago.
Here are some progress.
I've started to built the hull shell with 0.5 mm aluminum.
Hammering the sheet aluminum on a small anvil to get the shape.
One of the good things about using the aluminum sheet is you can scribe the panel line on a flat surface at the first place.
And then bend it or shape it.
And fitted on the structure.
[/URL]
For the second and the third deck.
I've just used some tiny rivet to hold the shell for now.
When every parts are fitted and trimmed. I put them out again and paint it.
Still long way to go but thanks for your support.
Katsu
Here are some progress.
I've started to built the hull shell with 0.5 mm aluminum.
Hammering the sheet aluminum on a small anvil to get the shape.
One of the good things about using the aluminum sheet is you can scribe the panel line on a flat surface at the first place.
And then bend it or shape it.
And fitted on the structure.
For the second and the third deck.
I've just used some tiny rivet to hold the shell for now.
When every parts are fitted and trimmed. I put them out again and paint it.
Still long way to go but thanks for your support.
Katsu