don't worry just cleaned enough to use it without painting my hands in black....
I don't know if I will make a blade holder,if possible,probably not for a 1" blade,may be a 7/8" blade.
It's only 26mm inside and a 1" blade leaves only 0,25mm wall for the blade holder,wow short....
I took a look at my male,interesting,it has some shiny areas,and other are not and there is a engraving on the back.
I think it has been modified in the past.
I was really surprised to see Sporak(RPF member) obiwan lightsaber emitter,with really thick front ring,and shape between male and female...
I think my male has been grinded from this kind of balance pipe:
-the back has been cut,to reduce the thickness
-the front has been cut,to remove the "half female" shape,makes same thickness on fin as the female now.
I don't know if I will make a blade holder,if possible,probably not for a 1" blade,may be a 7/8" blade.
It's only 26mm inside and a 1" blade leaves only 0,25mm wall for the blade holder,wow short....
I took a look at my male,interesting,it has some shiny areas,and other are not and there is a engraving on the back.
I think it has been modified in the past.
I was really surprised to see Sporak(RPF member) obiwan lightsaber emitter,with really thick front ring,and shape between male and female...
I think my male has been grinded from this kind of balance pipe:
-the back has been cut,to reduce the thickness
-the front has been cut,to remove the "half female" shape,makes same thickness on fin as the female now.