Hey Hunters,
every P1 bio I have ever seen has it's own flavor so I thought I would give it a go myself.
I started by using an old bio Ruffkin gave me and began to add clay pretty much all over.
I then cast it using the silicon caulk tubes method just to get a raw one I could fill and sand and tweak.
It is a real bitch trying to get it symmetrical. I am taking photos and drawing grid lines on a computer to check
for symmetry and finding out that your eye really plays tricks on you here. so then I keep adding a little filler here and sanding and grinding a little there.
Here is the progress so far. I still have a ways to go but I kinda like the way its coming out.
I want to drill out and recess the center of the laser shroud instead of have it protrude out a little and I need to cast up the
hose port and cheek port.
When I feel its done I will cast it up right and make some pulls.
Comments are always welcome
Thanks
VinMan
every P1 bio I have ever seen has it's own flavor so I thought I would give it a go myself.
I started by using an old bio Ruffkin gave me and began to add clay pretty much all over.
I then cast it using the silicon caulk tubes method just to get a raw one I could fill and sand and tweak.
It is a real bitch trying to get it symmetrical. I am taking photos and drawing grid lines on a computer to check
for symmetry and finding out that your eye really plays tricks on you here. so then I keep adding a little filler here and sanding and grinding a little there.
Here is the progress so far. I still have a ways to go but I kinda like the way its coming out.
I want to drill out and recess the center of the laser shroud instead of have it protrude out a little and I need to cast up the
hose port and cheek port.
When I feel its done I will cast it up right and make some pulls.
Comments are always welcome
Thanks
VinMan