Tri-Laser alignment & enclosure. Any suggestions?

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


reaver1

New Member
OK, so I have 3 diodes, wired and rigged with a 9volt battery. Now how do I get these little suckers to line up, and stay aligned? And what should I mount them in, prior to plugging them into a bio? I was thinking a small flashlight enclosure, but I'm guessing I'd need to get the lasers permanently aligned prior to inserting into an enclosure, due to space... What do you all think? Anyone done this, that could throw me a few pointers? Many thanks!
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top