Tri-Laser alignment & enclosure. Any suggestions?

R

reaver1

New Member
OK, so I have 3 diodes, wired and rigged with a 9volt battery. Now how do I get these little suckers to line up, and stay aligned? And what should I mount them in, prior to plugging them into a bio? I was thinking a small flashlight enclosure, but I'm guessing I'd need to get the lasers permanently aligned prior to inserting into an enclosure, due to space... What do you all think? Anyone done this, that could throw me a few pointers? Many thanks!
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Goldenrod
Tri-lazer housing
Replies
2
Views
852
Goldenrod
Goldenrod
surrealkiller1
Any hands around
Replies
0
Views
530
surrealkiller1
surrealkiller1
RiggsMcClane
Who sells raw bio helmets anymore?
Replies
6
Views
1,576
ksj
ksj
C
Soon to begin first attempt at DIY suit, any tips?
Replies
17
Views
2,979
The Fugitive
The Fugitive
ksj
Debouncer for arduino using 2 buttons for 2 leds (each button triggers a different led)
Replies
1
Views
753
ksj
ksj
Back
Top