Done / Completed The Diviner from Agents of S.H.I.E.L.D. Print pic #15

TheRocketeer

TheRocketeer

Master Member
So Bimmer and I have been working on this for the last 6-7 months.. and I have most of it printed.. still have a few pieces to print then assemble. I'm printing at super hi res so the full octagon texture will cover the diviner and the Kree symbols will be just like the renders I'm posting.

It'll be 12" tall roughly the same as the TV prop :)

I'm going to try and have the symbols light up and have the rest stay opaque. We will see how that goes, but we have a plan in place.

I'm thinking a for a resin cast it would be $145usd and to have a light up version it would be around $170usd + shipping based on your location.. these prices may change depending on how hard its going to be to get it to light properly.

So here are some renders of the model we are making :)

untitled.9.jpguntitled.10.jpguntitled.11.jpg

Here is one of the prints, which is the detail we are aiming for

cap_print.jpg


Please post interest. I would need at least 10 in to make this happen :)
 
Last edited:
Re: The Diviner from Agents of S.H.I.E.L.D.

Yeah the light up version sounds very intriguing.
 
Re: The Diviner from Agents of S.H.I.E.L.D.

Ok here are one of the pieces that I printed, re printing a few pieces that didnt pass inspection...so stay tuned :)

cap_print.jpg

Thanks :)
Sunkistshark said:
Keeping my eye on this! Count me in, your work is always steller
Click to expand...

Considered :)
SpiderBilly said:
Consider me interested. :thumbsup
Click to expand...

On the list
bluecoyote said:
interested
Click to expand...

Listed :)
Captain France said:
Interested ^^
Click to expand...

Here some more to watch
bobatrek said:
Watching this...
Click to expand...

I'll need to figure a few things out still but I think its doable :)
RobI said:
Yeah the light up version sounds very intriguing.
Click to expand...

So much :)
Bimmer said:
Just saw a teaser pic of some of the pieces. This go thing is gonna be gorgeous. So. Much. Detail!
Click to expand...
 
Last edited:
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

bobatrek
Limited Run S.H.I.E.L.D. Academy of Science and Technology pin
Replies
1
Views
219
enterprise0216
enterprise0216
PropsToHistory
Interest 20000 Leagues Newspaper from original print block
2 3 4
Replies
61
Views
3,577
center68
C
Indy Magnoli
Limited Run Map of Hyrule from the Legend of Zelda (by Magnoli Props)
Replies
12
Views
1,045
Magnoli Props
Magnoli Props
Saberbay
Limited Run "The Turn" Jedi Dooku Hilt From Tales of the Jedi -Pre Orders available
Replies
0
Views
1,031
Saberbay
Saberbay
Sarednab
Interest Indiana Jones and the Dial of Destiny - Destiny Journal
2
Replies
26
Views
1,754
MichaelFuji
MichaelFuji
Back
Top