TheRocketeer
Master Member
So Bimmer and I have been working on this for the last 6-7 months.. and I have most of it printed.. still have a few pieces to print then assemble. I'm printing at super hi res so the full octagon texture will cover the diviner and the Kree symbols will be just like the renders I'm posting.
It'll be 12" tall roughly the same as the TV prop
I'm going to try and have the symbols light up and have the rest stay opaque. We will see how that goes, but we have a plan in place.
I'm thinking a for a resin cast it would be $145usd and to have a light up version it would be around $170usd + shipping based on your location.. these prices may change depending on how hard its going to be to get it to light properly.
So here are some renders of the model we are making
Here is one of the prints, which is the detail we are aiming for
Please post interest. I would need at least 10 in to make this happen
It'll be 12" tall roughly the same as the TV prop
I'm going to try and have the symbols light up and have the rest stay opaque. We will see how that goes, but we have a plan in place.
I'm thinking a for a resin cast it would be $145usd and to have a light up version it would be around $170usd + shipping based on your location.. these prices may change depending on how hard its going to be to get it to light properly.
So here are some renders of the model we are making
Here is one of the prints, which is the detail we are aiming for
Please post interest. I would need at least 10 in to make this happen
Last edited:
