Smoothing, Sealing, and Painting Mk III

Thread starter BlueSteel
Start date Apr 20, 2015

BlueSteel

Guest

Apr 20, 2015

Hey all. Approaching finishing my Iron Man build but Im not sure how I should go about the coating smoothing and painting. It is fairly clean with a couple pretty rough spots (back of the calf, for example) and the only real problems are obviously the hot glue spots and crevices on parts, many are on oddly shaped pieces and such. After tons of research Im hearing a lot about plastidip and smooth on epsilon . I heard the latter eliminates the need for pva coats and allows you to paint right on it but it is also quite expensive. Oh and this build is on Eva foam. I'm mostly concerned about being able to get a smooth surface on a couple nasty spots and how to preserve detail lines that are intended to be on the suit. Thanks

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.