Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


NuadaDesigns

Well-Known Member
RPF PREMIUM MEMBER
Was able to piece this together with some failed prints from a while back, worbla, a 3D pen and some milliput.
The face mask was printed and then fixed with milliput. The cowl worbla, using a 3d pen for the details.
The large blades were made with a 3D pen and a thin layer of milliput. My cat has since knocked this helmet over and smashed it, but I managed to get a few pics before they did.
Cowl painted with Montana copper, backwash and highlighted with a Molotov chrome pen. Face mask and blades painted with Spaz Stix ultimate chrome.
20200422_221919.jpg
20200422_221904.jpg
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top