I was able to combine these two sections......it's a pretty tall part
and just made it with the size plastic i have for this former. Actually
the plastic pulled away from the frame when i set it down! Al thanks for the
wax tip worked well later for me!:thumbsup
I cut the top out to help it release later after the sanding....
Sanding the very top stage to sharpen it up......the black plastic is nice
because as you sand it it tells you where you miss.......anything shinny
and black you missed or have a low spot.I didnt have many low spots....:thumbsup Then i sanded the lower stage up into the top
until it was sharp.
Inside....
For the bottom of this section I cut a piece of 3mm and just taped it for now.....later i am thinking I can drill a hole and run the armature through sections like this.
This is another buck i made just wood laminated with 3mm styrene
to make the height. It will be the ring that separates this stage from the main stage once its vacuum formed.
Mock up......