Rey's Speeder from episode 7

[dotgov]

Am working on a model of Rey' Speeder from The Force Awakens along side my imperial probe droid build.
Once again I am building the model in 3d in Maya and printing it out on a xyz jr 1.0 3d printer.
Will post as I go but here is the grill as 2 parts and snapped together. Note I was able to print it with open grill and the part is about 1'X2.5"

- - - Updated - - -

Here is the geometry for the 3d model

 

[dotgov]

Here is a peek at the next part printing. Its a two part piece of the nose section including some damage.

 

[crackerjazz]

Cool stuff!

 

[cirrusx1]

Great job!!

 

[bigcow]

yes super wow ....

 

[dotgov]

Here is a peek at the next part printing. Its a two part piece of the nose section including some damage.
View attachment 574123View attachment 574122View attachment 574121View attachment 574120

- - - Updated - - -

Thanks everyone!

So I am new to 3d printing (my 1st project, well that and the droid) so im learning as I go.
I had to rebuild the nose section into 4 parts to minimize the overhangs.
here is the new layout. The parts are all keyed so hopefully everything will fit snug when they print.
Will post images as they finish

 

[dotgov]

Printing nose section so far so good.

 

[dotgov]

More progress tonight.
grill shell joined with minimal filler required
top and bottom caps printing now