Quick Han ESB DL-44/Denix Mauser question...

conceitedape

conceitedape

New Member
Heya!

Sorry if this has been covered before but what adhesives are you folks using to affix the 'motor coil' piece (plastic or resin copy) to your metal Mausers for the Han ESB blaster. Just want to make sure I don't use a solvent that may eat into the plastic, or resin for that matter.

Many thanks. :)
 
5min epoxy. Rough both parts up to give the glue a place to hold, and then add the epoxy. Wipe immediatly away whatever squeezes out.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

D
Clear plastic stands for the denix dl-44
Replies
0
Views
173
Dov3
D
chubsANDdoggers
Han Solo’s Hoth DL-44 Blaster from TESB..
Replies
8
Views
703
chubsANDdoggers
chubsANDdoggers
chubsANDdoggers
Han Solo’s Endor DL-44 Blaster from ROTJ..
Replies
14
Views
1,194
chubsANDdoggers
chubsANDdoggers
ThomasofTacoma
My first DL-44
Replies
1
Views
548
chubsANDdoggers
chubsANDdoggers
D
Showing off my ANH Hero DL-44
Replies
1
Views
233
greenmachines
greenmachines
Back
Top