Right? I mean, it may not be as sharp a pull as something like the TM, but I wouldn't be surprised if it fetched quite a bit, simply for what it is. A pull from a production mold (if that is indeed the case).Sweet looking lid. $2-$3,000? Seems doable... probably could go for $5-$6,000 in the first 5 minutes.
Does anyone know how the dome sits on the facemask since it's 3M tabs? I ask PropStore by email but I think they are too busy at the moment to answer me [emoji23]
I doubt there is any connecting/mounting solution. The dome is more than likely just resting on the facemask. The tabs are part of the facemask casting and don't actually have the little "nubs" that would attach to anything.
It's not a TM casting though. It's a production casting with the same pedigree as the original TM. To say it's a TM casting is implying that it's cast from a mold taken off the TM a generation down.
Ben