Official V3 Nike MAG Replica Thread - V3 Discussion Thread
- Thread starter cavx
- Start date
dreamcometrue
New Member
About a week. You will get status updates on each step. Enjoy!
cavx
Master Member
I used Kentucky Sky (lighter blue), but most here used Navy. Just make sure you get the synthetic RIT dye (comes in a bottle pre-mixed), not the normal cloth dye (normally comes in a foil pouch, that you mix in water).
cavx
Master Member
2mm.
Does anyone know the name of the Netflix doco about the MAGs?
Sent from my CPH1701 using Tapatalk
AjiPro
Sr Member
cavx
Master Member
AjiPro
Sr Member
cavx
Master Member
That was good. Wow, how much better the HC MAG could have been if they had made them look like the prototype auto lace MAG. That midsole was definitely the same used on the HC.
Sent from my CPH1701 using Tapatalk
AjiPro
Sr Member
I actually haven't seen it, I should take a look tomorrow
Sent from my VS996 using Tapatalk
cavx
Master Member
I wish it had shown a bit more about EARL.
They show a drawing of grey hi-top that I'd like to see relessed with EARL.
Sent from my CPH1701 using Tapatalk
WizardBTTF
Sr Member
cavx
Master Member
These 2mm OD / 0.7mm ID plugs were all I could get.
cavx
Master Member
0.5mm OD should not make a difference. The 0.7mm inner is what matters. Mine are DC charge port tips that plug into USB to DC leads. Maybe that is why there is 0.5mm difference.
marine boy
New Member
Hi all, 1st post. Just bought my first V3s off an ebay seller. Following the recent price drop, i have now ordered a 2nd pair from sneakerahead. I've been wearing modded V2s for a while now, so have been following this forum for a while.
My first mod to the V3s was to the charger, not the shoes themselves. Owners will know, the charge ports are awkward and can lead to damaged sockets. I modded the plugs, by trimming the plastic down, without exposing the metal inner. This makes it much easier to connect and puts less strain on the sockets. A very easy mod that will hopefully avoid problems later.
My first mod to the V3s was to the charger, not the shoes themselves. Owners will know, the charge ports are awkward and can lead to damaged sockets. I modded the plugs, by trimming the plastic down, without exposing the metal inner. This makes it much easier to connect and puts less strain on the sockets. A very easy mod that will hopefully avoid problems later.
AjiPro
Sr Member
As far as I know, no. The only change was the dimmer LED's
Sent from my VS996 using Tapatalk
cavx
Master Member
And the addition of some tape on the back of the EL panel on the sole.
Sent from my CPH1701 using Tapatalk
Similar threads
