My Arnold Schwarzenegger 1:1 clay
- Thread starter batara
- Start date
Too Much Garlic
Master Member
Very nice introduction and welcome to the forum. The detail work on this sculpt is pretty impressive. If you are okay with constructive criticism, then perhaps the jaw and lower part of the face from under the nose tip is a tiny bit too extreme for the rest of the sculpt. As if it doesn't really fit in, a bit too large. However, if the style is to make a bit of a caricature of Arnold, then I'd say you hit it out of the ballpark with this one.
Still amazed by the level of detail on this piece.
Good luck.
Still amazed by the level of detail on this piece.
Good luck.
PhantomProphet
Active Member
jaw dropping cool... nice work
Too Much Garlic
Master Member
Hello from Denmark.
Hope this helps a bit.
I don't know if it is clear what I did here, but I basically cut out the jaw, chin and mouth section - the shape seen in the lower right corner and just repositioned the rear of the jaw under the ears higher, angling the rest of the piece, so the overall look of the jaw is less protruding as before. You can spot where the old jaw/chin/mouth extended to compared to the rework. It may still be a tad bit too forward, but cutting it out, reposition it and blending it back in could do the trick without having to resculpt the whole jaw section.
