Whitechapelfx
New Member
Hey everyone! I'm just starting out making masks, I've made 2 so far but only ever just brushed layers into the mould, recently I've been looking at injection moulding but don't have a degassing chamber.
I was searching the forum earlier today & saw a mention on gravity pouring, which I'm hoping will be a good way to make the masks, but I don't fully understand how to do it... (I read about air holes & vents being needed in particular places, so I was just wondering if anyone here had any experience of it that they'd be able to share? Or even a good place to find out a bit more about it.
I hope someone can help & thanks for your time!
Paul.
I was searching the forum earlier today & saw a mention on gravity pouring, which I'm hoping will be a good way to make the masks, but I don't fully understand how to do it... (I read about air holes & vents being needed in particular places, so I was just wondering if anyone here had any experience of it that they'd be able to share? Or even a good place to find out a bit more about it.
I hope someone can help & thanks for your time!
Paul.