Making a helmet mold

wtyler3

Well-Known Member
RPF PREMIUM MEMBER
I need to make molds of several helmets I have been working on. I am looking for an "easy" way to cover the large openings for the face, head..... Anyone got a good technique?
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top