Kylo Ren Hasbro Force FX Lightsaber

I got the tubes at Home Depot in the lighting section. They are about 4 feet long, which gives enough for all three blades. Did have to cut them down. The middle so they would fit better.
 
My camera is broken at the moment. But all I did was cut the tubes to length (to fit over the blades), then used some clear sealing gel to create "flame" patterns on them. Somebody else did it and had pictures a few pages back on here.
*edit* it's on page 20
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Anakin Starkiller
The Anti-Hero: Kylo Ren Hero Saber design thread
Replies
11
Views
894
Rexermus
Rexermus
fr33d0m
Darth vader force fx lightsaber faded chrome paint on hilt
2
Replies
31
Views
1,985
fr33d0m
fr33d0m
spidey2
Hasbro Xwing upgrade
Replies
7
Views
424
TerranCmdr
TerranCmdr
nightlyfob79
Kylo Ren Black Series Helmet repaint pic heavy
Replies
3
Views
818
nightlyfob79
nightlyfob79
Anakins father
Lightsaber 3d modeling and blueprints
Replies
3
Views
537
Ridire Firean
R
Back
Top