Kylo Ren Hasbro Force FX Lightsaber

ViperDeCobray

Active Member
I got the tubes at Home Depot in the lighting section. They are about 4 feet long, which gives enough for all three blades. Did have to cut them down. The middle so they would fit better.
 

ViperDeCobray

Active Member
My camera is broken at the moment. But all I did was cut the tubes to length (to fit over the blades), then used some clear sealing gel to create "flame" patterns on them. Somebody else did it and had pictures a few pages back on here.
*edit* it's on page 20
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top