-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Interest INT: Active project: 1:1 accurate MAUSER REPLICA is READY!!!
- Thread starter scottjua
- Start date
DarkJedi360
Active Member
As much as I hate to do this, I'm going to have to drop out. I'm really sorry about that but my car had broken down and I'm gonna need money to replace it :cry
newmagrathea
Sr Member
You know what, just put me down for one Steel with no sight, removable bottom plate, swing safety only
I'm guessing if this gets under way then it'll be a while and I should be financially recovered. I can always throw it on the CC if I have to.
I'm guessing if this gets under way then it'll be a while and I should be financially recovered. I can always throw it on the CC if I have to.
Last edited by a moderator:
Up for a Steel one, no front sight, removable or non removable plate, swing safety, hammer trigger.Sweet!!!
Thanks,
AL
Thanks,
AL
Bbabylonia20
Well-Known Member
Do you think it would be possibility to ship the kit in several parts? For those of us over in the U.K. It may be the only way to get them into the country. It's a method I've used for Blade Runner Blasters before and it's worked just fine. I guess it could be an important point for those of us on the list already
imaginager
Sr Member
I'm in. The Denix is so rough... Steel, no front sight, removable magazine plate, swing safety only.
Buuuuump for interest! :$
imaginager
Sr Member
Goin' with the popular vote.....Steel, no front sight, removable magazine plate, swing safety.
As for the bolt, it doesn't have to be sliding, but can it at least be a separate piece? It could be held in place with
a screw hidden under the rear sight.
As for the bolt, it doesn't have to be sliding, but can it at least be a separate piece? It could be held in place with
a screw hidden under the rear sight.
Last edited:
kpax
Sr Member
It has to be made as a separate piece anyway so to put a place for a spring would be logical. I would think the bolt lock would hold it in place like the MGC.
Cool. :thumbsup
Similar threads
