How do I transfer a pattern to plaster?

Discussion in 'Replica Props' started by TFrosst, Apr 2, 2006.

  1. TFrosst

    TFrosst Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,146
    If I poured a flat piece of plaster and want to start carving something in it, how should I go about transferring the pattern? Would carbon paper work?
     
  2. division 6

    division 6 Master Member

    Trophy Points:
    3,045
    Carbon paper should work fine or you can just go over the design on the back with a pencil than trace it.

    Or just use a fair amount of preasure with a ball point pen to indent the design into the face of the plaster.

    D6
     

Share This Page