TheNerdyDad
New Member
I have been on multiple forums and I can't seem to figure this problem out. I have seen a lot of gatekeeper communities where there are specific answers and tricks about a proton pack assembly that people don't want to give away and I am hoping that this site's community is different.
I have my shell completed. I have my metal Motherboard. How do I connect the two? I have looked at using angle "L" shaped brackets, but after I connected them to the metal board, I can't figure out how to connect them to the shell and still have access when I need it?
I started making this pack about 3 years ago and my biggest help on this stopped all contact because I didn't want to vote for whom he wanted as President. So now I am stuck with searching the internet for my answers like a detective searching for Cuthuluh Mythos.
Any help would be greatly appreciated.
I have my shell completed. I have my metal Motherboard. How do I connect the two? I have looked at using angle "L" shaped brackets, but after I connected them to the metal board, I can't figure out how to connect them to the shell and still have access when I need it?
I started making this pack about 3 years ago and my biggest help on this stopped all contact because I didn't want to vote for whom he wanted as President. So now I am stuck with searching the internet for my answers like a detective searching for Cuthuluh Mythos.
Any help would be greatly appreciated.