foam mark 6

Thread starter cougar184
Start date May 10, 2013

cougar184

Well-Known Member

May 10, 2013

hey guys wanted to show off some progress on my mark 6 foam armor. this is my first attempt at folding foam pieces. I started with the chest and back learned a lot thru that process. then the shoulder bells and 1 arm. was not happy with the first arm that I made was out of thicker foam and was a tight fit so decided to redo those. a lot happier with the results.

- - - Updated - - -

here are a couple pics of some foam suits that I had the pleasure of sealing and painting

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.