This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
I returned from travel to find this amazing kit had arrived. This is a VERY clean 3D print with out a lot of supports to deal with. I only saw one small piece with a tad bit of support on it. Very tempted to buy the others kits and sell the Weta versions!
Thanks for posting and the compliments! Stoked you like the kit so much.
Thanks to you mate for making these available and sharing your work on here.
Payment sent for one SMG kit,
Are you pinning the parts? I am planning on pinning the larger assemblies together with 1/4 brass rod and the small tubes with either 3mm brass rod or pieces of wire coat hanger, whichever works best.
For anyone working on this kit in the US - the guide holes in the kit are 8mm wide. I had a hard time finding a metric rod for a decent price, but I found a 5/16" threaded stainless steel rod at Home Depot that fits the holes pretty well.
payment sent