Nm1cciola
Active Member
If this isn't the right place to post this then please let me know where would be the best place to post this. Long story short I am just asking advice on how to best go about modding this helmet in order for it to be a co-void mask. So while I am good at cutting and creating new bands for the masks I am a noob at the electrical component of creating effects and the like. I have seen a few youtube videos of peoples setup on how they do the voice changer and stuff like that. But how would one go about modding this helmet in such a way that the electronics can still be used even when it's going to be cut so severely. Pictures of the helmet broken down will be attached, and any advice is welcome.
PS
Also if need be I know that the electronic component can hang from the helmet but would it be possible to sandwich them into a half face mask.
PS
Also if need be I know that the electronic component can hang from the helmet but would it be possible to sandwich them into a half face mask.