Custom name plates for my helmets

Thread starter merkava74
Start date Jun 7, 2015

merkava74

Sr Member

RPF PREMIUM MEMBER

Jun 7, 2015

Not sure if this is the correct place to post this, mods please advice, thanks.

Wanted to showcase how I made my custom name plates for my helmets.

Photo%207-6-15%203%2031%2039%20pm_zpsbq71n4jz.jpg

It is essentially an aluminium plate measuring 14.5cm x 6cm, with vinyl cut out letterings on it, and a simple bent stand at the back to hold the plate at an angle. Figured that I could make any design that I wanted, so why not?

What do you guys think?

Photo%207-6-15%203%2031%2046%20pm_zpseo0cijj4.jpg

Photo%207-6-15%203%2031%2054%20pm_zpso2u8f3wv.jpg

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.