Custom name plates for my helmets

Thread starter merkava74
Start date Jun 7, 2015

merkava74

Sr Member

RPF PREMIUM MEMBER

Jun 7, 2015

Not sure if this is the correct place to post this, mods please advice, thanks.

Wanted to showcase how I made my custom name plates for my helmets.

Photo%207-6-15%203%2031%2039%20pm_zpsbq71n4jz.jpg

It is essentially an aluminium plate measuring 14.5cm x 6cm, with vinyl cut out letterings on it, and a simple bent stand at the back to hold the plate at an angle. Figured that I could make any design that I wanted, so why not?

What do you guys think?

Photo%207-6-15%203%2031%2046%20pm_zpseo0cijj4.jpg

Photo%207-6-15%203%2031%2054%20pm_zpso2u8f3wv.jpg

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.