Limited Run Control Box PCB for Roman Props Balance V4 | Accepting Payments | Now Shipping

[Schepeey]

Are you going to continue offering these or is this a limited run? Don’t have a balance yet, but thinking about down the road...

 

[Halliwax]

Just to confirm, SWX- is for the grounding wires for SW1 + and SW2+ ?

I am far from a electrical expert, and everything else on the board seems very self explanatory, I just want to double and triple check

Sent from my iPhone using Tapatalk

 

[knullzero]

Just to confirm, SWX- is for the grounding wires for SW1 + and SW2+ ?

I am far from a electrical expert, and everything else on the board seems very self explanatory, I just want to double and triple check


Sent from my iPhone using Tapatalk

Sorry I didn't see this sooner. The negative pads are ground. If you are using a Plecter board you can even bridge the SWX- and LED- pads to have a single ground running back to your board.

- - - Updated - - -

Do you have the instructions for these parts on where to drill the holes etc? Cheers

The build thread is strangely missing... Let me check on that.

 

[Joek3rr]

Sorry I didn't see this sooner. The negative pads are ground. If you are using a Plecter board you can even bridge the SWX- and LED- pads to have a single ground running back to your board.

- - - Updated - - -



The build thread is strangely missing... Let me check on that.

Did instructions get made and posted somewhere? I have a bad habit of missing important stuff.

 

[BritWalker]

Sorry guys to sound a fool, but got a bit lost between threads. @ knullzero are you taking orders for the new V4 yet?

 

[BRRogers]

Hey guys, what resistors are you using for the LEDs? I'm a dummy and I jumped in before looking. Before I powered this up i realized i forgot to account for this and I don't see it mentioned here specifically

 

[sithlord1968]

Are there any of these left for purchase?

 

[knullzero]

Are there any of these left for purchase?

Yes, I’ve been closed for a while, but recently reopened my store. You can get them at saberstuff.com.

 

[SilantStrike]

The build thread is strangely missing... Let me check on that.

Hi there, did you ever locate the build thread? I am installing the new design PCB into a second run balance, and the switch plungers do not line up properly with the copper plate holes that came with the kit.

I'd like to confirm that drilling new holes is required )or making the existing holes larger, or if there is something amiss?

 

[BRRogers]

knullzero
turok96
did you still have stock of the faceplate/arrows remaining?