C96 Mauser Build for Red Skull Costume


Sr Member
Here is the finished version of my C96 Broomhandle Mauser build. Everything is hand cut from sintra, styrene and a bit of wood. The handle turned out really bad and will be redone soon. Now I know since this is the basis for the DL44 Blaster, that it may endure critical scrutiny, but I realise this is less than screen accurate. This is only meant to be a prop for my Red Skull costume I'm currently working on for DragonCon 2011. I will have a WIP thread for the Red Skull (old version, not movie version) as it comes along.



Last edited:
Very nice...do you want a set of Denix grips to upgrade yours?

Should have a spare one in my workshop

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.