MonsieurTox
Master Member
Thanks Mike ! Now I'm not sure my canopy has the correct size... I think it's a bit undersized :/
Somebody please give Julien the rest of the part ID's so I can see the Koolshade I just sent show up on his finished TIE model in the next 24 hours.
Kind Regards,
Matt
:lol
Julien,
I measured the top hatch I got from Richard Edlund. It is 79.75mm in diameter, according to my calipers.
Hope that helps. Will try and rustle up that other data later today.
Gene
Julien,
I measured the top hatch I got from Richard Edlund. It is 79.75mm in diameter, according to my calipers.
Hope that helps. Will try and rustle up that other data later today.
Gene
5-1/8" ball = 130.175mm
5" ball = 127mm
ratio = 1.025
GKvfx's hatch = 79.75mm (original part?)
Julien's hatch = 77.5mm
ratio = 1.029
Maybe the original ball wasn't a Plastruct Hemi?